SoCal Jet Boats

Tech Talk => Engine Mechanical / Electrical => Topic started by: NORCALWRIEDT on August 01, 2019, 09:33:55 PM

Title: Changed starter and now have no start.
Post by: NORCALWRIEDT on August 01, 2019, 09:33:55 PM

Changed the starter on my 460 ford and now have a no start. I went from a older ford starter to a 93 f350 style starter. I notice the old starter has one pole on it and the new has two. It cranks but no spark. Could I switch it to the ther pole? Any thoughts? Can’t find any diagrams. New one is the smaller brass one.

Title: Re: Changed starter and now have no start.
Post by: Grimpala on August 02, 2019, 06:37:11 AM

Where did the black/heat shrunk wire that was attached with the single yellow wire end up?

Title: Re: Changed starter and now have no start.
Post by: NORCALWRIEDT on August 02, 2019, 07:50:03 AM

All the wires are on the big pole, except for the signal wire. I’m wondering if it gets wired through the other pole? This newer starter has two poles on it.

Title: Re: Changed starter and now have no start.
Post by: NORCALWRIEDT on August 02, 2019, 09:37:09 AM

Anyone have any pics of the wiring of their early 90s 460 starter installed?

Title: Re: Changed starter and now have no start.
Post by: third degree on August 02, 2019, 09:00:53 PM

Check your grounds


Sent from my iPhone using SoCal Jet Boats