SoCal Jet Boats

Classifieds => WTB => Topic started by: svssr95 on September 27, 2009, 08:35:06 PM

Title: 460 Ford 40 over forged pistons
Post by: svssr95 on September 27, 2009, 08:35:06 PM

Anybody have any new ones lying around???

Title: Re: 460 Ford 40 over forged pistons
Post by: svssr95 on September 29, 2009, 06:54:17 PM

how bout some slightly used ones??

Title: Re: 460 Ford 40 over forged pistons
Post by: 78centurian on October 01, 2009, 06:03:06 PM

good looking out man but hes looking for forged pistons

Title: Re: 460 Ford 40 over forged pistons
Post by: svssr95 on October 02, 2009, 09:16:15 PM

Marc?

Title: Re: 460 Ford 40 over forged pistons
Post by: GlassCutter on October 02, 2009, 10:45:03 PM

Quote from: svssr95 on October 02, 2009, 09:16:15 PM

Marc?

Marcsrollin here (somewhere) on the board.   I believe he is a manager at San Diego Super Shops.
Somebody correct if I'm wrong cuz I'm pretty shit faced right now    :P

Title: Re: 460 Ford 40 over forged pistons
Post by: Marcsrollin on October 02, 2009, 10:59:27 PM

Quote from: GlassCutter on October 02, 2009, 10:45:03 PM

Marcsrollin here (somewhere) on the board.   I believe he is a manager at San Diego Super Shops.
Somebody correct if I'm wrong cuz I'm pretty shit faced right now    :P

Bingo! ;D

Title: Re: 460 Ford 40 over forged pistons
Post by: svssr95 on October 02, 2009, 11:03:41 PM

OK Marc, nows the time to present your smokin deal.......

Title: Re: 460 Ford 40 over forged pistons
Post by: LakesOnly on December 25, 2009, 03:17:14 PM

Quote from: svssr95 on September 27, 2009, 08:35:06 PM

Anybody have any new ones lying around???

What kind of pistons do you want? Flat top? Dome? Dish? Desired compression ratio? Is your block 0.040" over now?  0.040" pistons are available for 460's but usually by the higher end piston manufacturers.  Typically the mass produced 460 forgings go 0.030", 0.060", 0.080".

LO