Null


Pages: [1]

HomeBlown57

  • Karma: +0/-0
Gasket between droop and bowl?
« on: September 09, 2011, 10:08:49 AM »
Do I need it? Machined surface to machined surface.
Logged
  • Like
    Dislike
    Love
    HaHa
    Angry
    Surprise
    Sad
    Party

fastmarlene

  • Karma: +1/-0
Re: Gasket between droop and bowl?
« Reply #1 on: September 09, 2011, 11:25:23 AM »
Cannot say it works this way in every case but have no gasket between the bowl and droop on mine.  Just use thin layer of silicone.  Never leaked.  Have had it apart and back together a few times.  Need to be sure the surfaces are clean.
Logged
  • Like
    Dislike
    Love
    HaHa
    Angry
    Surprise
    Sad
    Party

Brad @ SCJB

  • Karma: +255/-0
Re: Gasket between droop and bowl?
« Reply #2 on: September 09, 2011, 02:17:25 PM »
on the cruisers i run bowl/wedge/wedge/rooster booster/wedge/nozzle adapater  ....not one gasket. ....all aluminum wedges. i dont have any problems.

i also run the booster on the race boat with a wedge combination, no gaskets and no problems

you dont HAVE to....you might get a little spray, but it doesnt hurt anything.
Logged
  • Boat #1: 1978 Liberty
  • Boat #2: 1982 Eliminator Sprint
  • Like
    Dislike
    Love
    HaHa
    Angry
    Surprise
    Sad
    Party
Pages: [1]
 


Null

SMFPacks CMS 1.0.3 © 2026